|
5809
Features:
ADEMCO’s 5809
wireless fixed heat and rate-of-rise temperature sensor offers
expanded fire detection and installation flexibility. It is
ideal for hard to wire locations and applications that require
more than smoke detection. With no wires to run, the 5809 is
fast and easy to install. The 5809 combines both rate-of-rise
and fixed temperature sensors. Fires typically cause a rapid
rise in temperature in the surrounding area. The 5809’s
rate-of-rise thermostat senses the rise in temperature and
signals an alarm if the increase is 15° or more per minute.
A built-in fixed temperature sensor will also signal an alarm if
the environmental temperature rises above 135°F. The 5809 is
UL Listed (UL521) and CSFM approved for commercial and
residential applications.
- Contains
a
built-in transmitter which can send alarm, supervisory and
battery condition messages to the system’s receiver/control
unit
- Powered
by
a three-volt lithium battery. If the battery voltage gets
too low, the 5809 sends a low battery signal to the control
panel
- Features
a
tamper switch, which causes a trouble signal to be sent to
the control if the unit is removed from the mounting base
- UL
Listed
for Commercial (when using 5881EH Receiver) or Residential
applications
Specifications:
Power
- 3V lithium
battery (Duracell DL123A, Panasonic CR123A, Sanyo CR123A,
Varta CR123A)
- Operating
temperature: 40° to 140°F (6° to 60°C)
- Rate-of-rise
temperature: 15°F (8°C) increase per minute (NOTE:
Rate-of-rise sensor does not operate above 38°C)
- Fixed
temperature: 135°F (57°C)
- Maximum
spacing: 50 ft x 50 ft UL, 30 ft x 30 ft FM (refer to
National Fire Alarm Code Standard NFPA 72 for application
requirements)
- Dimensions:
4.4” diameter/2/2” deep
*Prices are subject to change in accordance to exchange rate
|
CCTV Products
CCTV Cameras
