|
5808LST
Features:
The
5808LST Commercial/Residential Photoelectric Smoke and Heat
Detector has a built-in wireless transmitter and two concealed
thermistors for heat detection. For difficult to wire locations,
room aesthetics or even hazardous materials, like asbestos above
a drop ceiling, installation of these wireless devices provides
the cost effective solution. The 5808LST smoke/heat detector can
be used with 5881 series (L, M, H) for residential and 5881EH
receivers for commercial installations. The transmitter can send
alarm, tamper, maintenance low temperature alert (see control
panel specifications) and battery condition messages to the
system’s receiver. The maintenance signal will either indicate
that the photo-chamber requires cleaning or that the detector
can no longer respond to smoke and may need replacement. Refer
to the wireless system’s instructions for the maximum number of
transmitters that can be supported. The 5808LST sounds its
built-in temporal code 3 sounder when smoke reaches the detector
(the LED also flashes rapidly) or when the air temperature
reaches 135°F (the LED flashes normally, about once every 40
seconds). A message is also sent to the wireless control panel
and the smoke detector’s ID number is displayed at the console.
During normal, maintenance, and low battery conditions, the LED
flashes approximately once every 40 seconds.
- Extended Battery Life
- two 3 volt Lithium
- Automatic Drift
Compensation
- Smart Check (TM) -
Pre-alarm Maintenance Signal
- Test/Alarm - Silence
Button - immediate signal 2.5 sec Delay Horn activation
- Field Replaceable
Chamber
- Heat Detector - dual
135 Degree Thermistors
- Low Temperature Alert
Signal
- Pre-Low Battery signal
to central station (if applicable) 7 days prior to horn
chirp
- UL 268 - Commercial
and Residential
Specifications:
|
Power source
|
Two-volt CR123A lithium
batteries (included).
Replace with Duracell
DL123A, Sanyo CR123A,
Panasonic CR123A, ADEMCO
466, or Varta
CR123.
|
|
Maintenance limits
(maintenance
is activated at either
smoke level)
|
Hot sensitivity: 0.65% +
0.15% per foot
Cold sensitivity: less
than 6% per foot
|
|
Height
|
2.5 inches (14 cm)
|
|
Diameter
|
5.5 inches (64 mm)
|
|
Weight
|
0.7 lb. (310 g)
|
|
Operating ambient
temperature range
|
4.4° to 37.8°C
(40° to 100°F)
|
|
Operating humidity range
|
5% TO 95% relative
humidity
|
|
Heat sensor
|
135°F fixed
temperature electronic thermistors
|
|
Low Temperature Signal
|
45°F fixed temperature
electronic thermistors
|
|
Agency listings
|
UL 268 - Commercial and
Residential Installations
|
*Prices are subject to
change in accordance to exchange rate
|
CCTV Products
CCTV Cameras
